Regency U32-NG3 - Manual (Page 13)

13 U32-3 FPI Direct Vent Gas Insert
THIS CONVERSION MUST BE DONE BY A QUALIFIED GAS FITTER
IF IN DOUBT DO NOT DO THIS CONVERSION !!
Conversion Kit from Natural Gas to Propane Model #512-969
1) Turn the unit off and allow it to cool to room temperature.
2) Unplug or disconnect power source to stove.
3) Remove glass front (see manual).
4) Remove logs and brick panels (if installed).
5) Remove the Grate by removing the screws on each side of the grate.
Remove the 2 screws holding the grate in position.
Remove the 2 screws,
push Burner Tray to the left, and lift off.
6) Remove the Burner Tray by removing the screws on each side of
the tray. Push the tray to the left and lift up.
7) Remove burner orifice with 1/2"
wrench and replace with the
#52 orifice in the Kit.
Diagram 1
Burner
Orifice
9) Pull off the pilot cap to expose
the pilot orifice.
10) Unscrew the pilot orifice with
the allen key (provided) and
replace with the LP pilot orifice
in the kit.
8) Remove regulator from valve and replace with Propane regulator.
See diagram 1.
11) Replace Burner Tray and reverse steps 5) to 1).
12) Place the red "Converted to Propane" sticker on top of the Natural Gas
information on the Serial Number decal.
13) Adjust the burner aeration setting from 3/16" to 1/4" as required for
the best flame picture.
INSTALLATION