Regency U32-NG3 - Manual (Page 25)

25 U32-3 FPI Direct Vent Gas Insert
FAN MAINTENANCE
If your fan requires maintenance or replace-
ment, access to the fan is through the plate on
the rear wall of the firebox. NOTE: the unit
MUST NOT be operated without the fan
access panel securely in place.
Caution: Label all wires prior to
disconnecting when servicing con-
trols. Wiring errors can cause im-
proper and dangerous operation.
Verify proper operation after serv-
icing.
Bay Glass Removal
1) Remove the door from the unit and place on
a soft surface to prevent scratching.
2) Remove the nuts holding the glass retainers
in place.
3) Remove the glass retainers (sides, top and
bottom).
4) Replace the glass. The glass must have
gasketing around it.
5) Reverse the previous steps, replace the
retainers and fasten with the nuts but do not
over tighten, as this can break the glass.
6) Replace door on the stove and check the
seal.
MAINTENANCE
Grate screws
7) Remove the 2 screws holding the Air Intake
Hood to the rear firebox wall and lift out.
8) Remove the 10 screws holding the Access
Panel in place.
9) Remove the Fan Air Duct by loosening the
3 screws, squeeze the sides together to
remove.
TO REMOVE FAN:
1) Turn the unit off and allow it to cool to room
temperature.
2) Unplug or disconnect power source to
stove.
3) Remove glass front (see page 11).
4) Remove logs and brick panels, if used.
5) Remove the grate by loosening the two
screws and sliding the grate out.
6) Remove the burner/front log support as-
sembly by removing the 2 screws and
lifting it out.
Replacing fan:
Reverse above steps. Hint for pushing fan
down onto pins - rub a bit of dish soap on the
grommet so it will slide more easily onto the pin.
Check to make sure the fan is seated properly
on the pins, this is very important- try to move
the fan back and forth, there should be no noise,
if there is check that the grommets haven't come
loose.
Seal fan access panel using high temperature
silicone (sparingly).
10) Unplug the wires from the
fan motor (from inside the
stove).
11) Lift Fan Assembly off of
the 2 pins, tip forward
and pull through firebox
opening.
12) Disconnect green wire
from power cord.