Regency U32-NG3 - Manual (Page 17)

17 U32-3 FPI Direct Vent Gas Insert
HAMPTON CAST FACEPLATE
GRILL INSTALLATION
INSTALLATION
Note: The top louver should be placed with the
curved cut-out facing up.
11) Mount the cast faceplate panels onto the insert body, sliding the side
filler brackets into the space between the glass and the firebox.
Secure using the 4 remaining black screws, 2 per side.
U31 ONLY:
Install the glass trim by inserting the side hooks on the glass trim
into the 4 slots between the faceplate and the glass. Push the glass
trim down firmly with both hands to lock into place.
Slide side filler
bracket into gap
between glass and
fire box.
Side Hook
Slots
12) To put on the Hampton logo, peel the sticker from the back of the logo
and place it centered on the bottom left hand corner of the faceplate.
Hampton Logo Left Side
Faceplate
Before the grills are installed, a grill stop bracket needs to be put in place.
1) The U32 grill stop bracket is installed in the bottom left corner just under
the firebox as shown below.
2) Place top grill into brackets located inside top of firebox as shown.
Bracket inside
top of firebox.
3) The bottom louver, shown in the diagram below, has 2 hinges that
are attached to the lip on the bottom of the unit. Secure using 2 screws
per hinge.
U32 Grill
Stop
Bracket
Bracket
Top Grill