Error & status messages on the control panel, P.97 "error & status, Messages on the control panel – Ricoh BY1000 User Manual
Page 97
97
Troubleshooting
Error & Status Messages on the Control Panel
This section explains what the messages that appear on the control panel mean and what to do when a particu-
lar message appears.
Hardware Problem Ethernet
An error in the network interface board (ethernet board) network function has occurred.
See
p.117 "Network Interface Board Error"
.
Ink Collector is full/Replace Ink Collector Unit
The ink collector unit is full. Replace the ink collector unit.
Ink Collector almost full
The ink collector unit is almost full. Make sure you have a new ink collector on hand.
Low Ink
The ink runs out. Change the print cartridge.
See
p.39 "Replacing a Print Cartridge"
Loading Ink...
Ink is being supplied. Wait a moment.
Ink depleted
The ink in the indicated print cartridge has run out. Change the indicated print cartridge.
See
p.39 "Replacing a Print Cartridge"
Printing...
The printer is printing.
Ready
The printer is able to print.
Close Top Cover or reset the Duplex Unit correctly
The top cover is open or the duplex unit isn't set correctly. Close the top cover or reset the duplex unit correctly.
See
.
Power Off On / Call Service if error reoccurs
An error has occurred.
Switch the printer off and then on. If the message reappears, contact your service representative.
Offline
The printer is offline. To print, put the printer online.
Temp. alert Please wait...
The printer is too hot or cold at start-up.Wait until "Ready" appears on the control panel.