Ricoh BY1000 - Manual (Page 98)

98
Troubleshooting
Guide Board is open/Close the Guide Board
The guide board is open. Close the guide board.
Reset Cartridge
No print cartridge has been installed. Install the print cartridge correctly.
See
p.111 "Cover Open / Print Cartridge(s) Not Detected" .
Dry Waiting...
The ink on the printed OHP transparency is being allowed to dry.
Waiting...
Wait a moment.
Energy Saver
The printer is in Energy Saver mode. The printer is ready for use.
Cannot use High Temp./Power Off On
The temperature is abnormally high.
Switch the printer off and then on. If the message reappears, contact your service representative.
See
p.116 "Out of Printable Temperature Range" .
Cannot use Low Temp./Power Off On
The temperature is abnormally low.
Switch the printer off and then on. If the message reappears, contact your service representative.
See
p.116 "Out of Printable Temperature Range" .
Resetting Job...
The printer is reinitializing a print job.
Wait a moment.
Setting change
The printer is changing its settings. Wait a moment.
Load Paper:Tray# or Form Feed
The selected tray has run out of paper.
Reload the tray. Alternately, press the [Form Feed] key, select a different tray, and then print. To cancel the print
job, press the [Job Reset] key.
See
p.101 "No Paper/Tray Not Detected (Tray 1)" , p.103 "No Paper/Tray Not Detected (Bypass Tray)" .
Change Setting Tray #/
The size of paper in the selected tray does not match the specified paper size.
Load the tray with paper of the specified size, and then change the paper size setting for the tray on the control
panel. Alternately, press the [Form Feed] key, select a tray containing paper of the specified size, and then print.
To cancel the print job, press the [Job Reset] key.
See
p.104 "Paper Size Mismatch/Paper Type Mismatch (Tray 1)" , p.106 "Paper Size Mismatch/Paper Type
Mismatch (Bypass Tray)" .