Roland HPD-15 - Manual (Page 57)

57
Chapter 2 Modifying a Patch
Chapter 2
Copying a Pad Set (Pad Set Copy)
You can copy the settings of a pad set to another pad set. You
can also copy to a different pad set of the same patch.
fig.2-34.e
1. In step 3 of “Basic Procedure for Copy” (p. 56), select
PadSetCpy .
2. After selecting the patch in step 5, strike a pad to select a
pad set.
* “PAD MIDI Note No.” cannot be copied.
Copying Pad/D Beam/Ribbon
Settings (Pad Copy)
Pad/D Beam/ribbon settings can be copied to another pad/
D Beam/ribbon.
fig.2-35.e
1. In step 3 of “Basic Procedure for Copy” (p. 56), select
PadCpy .
2. After selecting the patch in step 5, strike a pad (D Beam,
ribbon) to select it.
* “PAD MIDI Note No.” cannot be copied.
Copying Pad/D Beam/Ribbon
Settings to All Pads
(Pad Copy to All)
You can copy the settings of one pad/D Beam/ribbon to
every pad/D Beam/ribbon.
fig.2-35a.e
1. In step 3 of “Basic Procedure for Copy” (p. 56), select
PadCpToAll .
2. After selecting the patch in step 5, strike a pad (D Beam,
ribbon) to select it.
* “PAD MIDI Note No.” cannot be copied.
Exchanging Patch Settings
(Patch Exchange)
You can exchange the settings of two patches.
fig.2-36.e
1. In step 3 of “Basic Procedure for Copy” (p. 56), select
PatchExchg .
U0101B Conga
PadSetCpy
U0201 C
copy-destination pad set (patch number is blinking)
copy-source pad set
U0101A3 Conga
PadCpy
U0101 RL
copy-destineation pad (patch number is blinking)
Ribbon controller (left) is chosen in this figure.
U0101A1 Conga
PadCpToAll
U0101
copy-destination patch number (blinking)
copy-source pad
U0101 Conga
PatchExchg
U0102
exchange-destination patch number (blinking)
exchange-source patch