Roland VG-99 - Manual (Page 163)

163
MASTER Chapter 9 Parameter Guide
Chapter 9
NAME/KEY/BPM
PATCH NAME
CATEGORY
KEY
BPM
AMP CONTROL
TX PC (Transmit Program Change)
PATCH LEVEL
Parameter/
Range
Explanation
PATCH NAME
This sets the Patch name.
INSERT Insert a space at the cursor location.
DELETE Delete a character. The characters that fol-
low get shifted to the left.
SPACE Input a space at the cursor location.
A0! Switch between uppercase letters, numbers,
and characters.
A<=>a Switch between uppercase letters and low-
ercase letters.
CATEGORY Sets the category for the current patch. Refer
to
“Separating Patches into Groups
(CATEGORY)” (p. 90)
Parameter/
Range
Explanation
CATEGORY
USER 1–10
ELECTRIC
ACOUSTIC
BASS
SYNTH
ROCK
JAZZ
ETHNIC
DYNAMIC
RIBBON This selects the Category name.
* You can set USER1–USER10 in
SYSTEM (p. 176).
Parameter/
Range
Explanation
KEY
C (Am)–B (G#m) This sets the key for the COSM guitar and
FX HARMONIST.
The key setting corresponds to the key of the song (#, b ) as follows.
Parameter/
Range
Explanation
BPM
40–250 Adjust the BPM value for each patch.
Parameter/
Range
Explanation
AMP CTL1, AMP CTL2
OFF, ON This setting switches the FC-300’s AMP CTL
1 and AMP CTL 2 parameters on and off.
Parameter/
Range
Explanation
You can assign whatever Program Change numbers you want to
patches.
* This setting is enabled when the SYSTEM MIDI TX PC MAP is set to
PROG (p. 171).
BANK MSB
OFF, 1–127 This sets the Bank Select (MSB) to be output.
BANK LSB
OFF, 1–127 This sets the Bank Select (LSB) to be output.
PC (Program Change)
1–128 This sets the Program Change to be output.
Parameter/
Range
Explanation
PATCH LEVEL
0–200 Adjusts the volume the patch.
* This parameter is the same as “PATCH
LEVEL” (p. 146) in MIXER.
Control with the Master BPM
You can tap input the BPM with [F1].
VG-99_e.book 163 ページ ２００７年７月５日 木曜日 午前９時２２分