Roland VG-99 - Manual (Page 70)

70
Chapter 6 Using MIDI
The MIDI channel over which the messages are output in
POLY mode is only the basic channel. In MONO mode,
the messages are output over the six channels spanning
from the basic channel up to the channel numbered five
above the basic channel.
Outputting Program Change Messages
Simultaneously When Switching
Patches (PC)
This sets the Program Change messages that are output when the
VG-99’s patches are switched.
* Program Change messages are not output while PC MASK (p. 66) is
set to ON.
1. Follow Steps 1–2 in “Setting the Transmission
Mode (MODE)” (p. 67) to display the GTR TO
MIDI screen.
2. Press PAGE [ ] [ ] to display Pages 3–5.
When MODE (p. 67) is set to MONO, you can make settings
individually for each of the six strings of STRING 1–6.
3. Make the settings with [F1]–[F6] or the F1–F6
knobs.
Set the following parameters.
The MIDI channel over which the messages are output in
POLY mode is only the basic channel. In MONO mode,
the messages are output over the six channels spanning
from the basic channel up to the channel numbered five
above the basic channel.
BANK MSB Explanation
OFF, 0–127 This sets the Bank Select (MSB).
BANK LSB Explanation
OFF, 0–127 This sets the Bank Select (LSB).
PC Explanation
OFF, 1–128 This sets the Program Number.
VG-99_e.book 70 ページ ２００７年７月５日 木曜日 午前９時２２分