Driver installation, Quick guide – Rosewill RC212 User Manual
Page 13
SATA+ULTRA ATA RAID CONTROLLER
RC212 User Manual
13
During this (POST) process, the BIOS will show up and indicate the devices attached
to it.
Driver Installation
Quick guide:
1.
If you want to add RC-212 to an existing OS, set up RC-212 into a PCI slot. Enter the
OS and install RC-212 with driver disk. In this case, PC is booting up by an existing HD
connecting to motherboard. After RC-212 is installed complete, you can add HD and
set the RAID by RAID BIOS.
2.
If you want to add RC-212 to a new PC without any OS, you need to boot the OS from
HD connecting to RC-212 instead of motherboard.
a. Put the driver (the driver must fit the OS you want to install to the HD) into a floppy
disk and keep it in the floppy drive.
b. Plug the HD. Turn on PC, enter and complete the RAID set. After you complete, save
and left the setting.
c. Inset Windows installation disk and start the windows installation.
d. Press F6 at the beginning as the blue screen scanning.
3.
Please follow below steps a~f to complete the installation.