Raritan Computer COMMANDCENTER NOC - Manual (Page 41)

C HAPTER 2: GENERAL AND ADVANCED ADMINISTRATION 29
address or a hostname that this appliance can resolve. Example: Protocol=Trap, Host=
192.168.51.150, Port=162.
8. Type protocol, host, and port for the Path Back URL which is the IP address or hostname of
this CC-NOC. The Host entered is the web address that a user of the external event recipient
can use to connect back to this appliance via a web browser. The external event recipient
might be on the other side of a firewall, however, and so the URL that a user would use to
access this appliance's web user interface is a required parameter when creating an event
recipient. Currently both HTTP and HTTPS are supported. Example: Protocol=HTTPS,
Host= 192.168.53.176, Port=443.
9. Click save.
Configure Event Severities to Forward
To instruct your CC-NOC to forward copies of its events as SNMP traps to other management
platforms or Raritan appliances, use Configure Event Severities to Forward to specify which
events should be forwarded.
1. Click on the Admin
tab in the top navigation bar.
2. Click Multi-site Management.
3. Click Configure Event Forwarding.
4. Click Configure Event Severities to Forward.
Figure 30 Configure Event Severities to Forward
5. Click the check boxes before the Event Severities you want to forward. All events matching
these severities will be forwarded to all recipients specified in Event Forwarding Recipient
– see section Configure Event Recipients earlier in this chapter. These changes will take
effect immediately.
6. Click save.
Note: For the purposes of event forwarding, the Critical and Cleared severities are equivalent. A
Cleared event occurs when a Critical situation, for example, a network outage has ended.
Configure Trap Relaying
This page allows you to configure where any incoming SNMP traps should be relayed. You can
relay incoming traps to a management platform or Raritan appliance. On this platform or
appliance resides an SNMP agent that listens for the traps.
1. Click on the Admin
tab in the top navigation bar.
2. Click Multi-site Management.