Raritan Computer COMMANDCENTER NOC - Manual (Page 42)

30 COMMANDCENTER NOC ADMINISTRATOR GUIDE
3. Click Configure Trap Relaying.
Figure 31 Configure Trap Relaying
4. Click add recipient.
Figure 32 Specifying Trap Recipient
5. Specify a hostname that is resolvable from this appliance or an IP address in the Host field.
This can be the same platform or appliance that was specified when configuring event
recipients – see section Configure Event Recipients earlier in this chapter for additional
information.
6. Type a port, for example, 162 on that host that is listening for incoming SNMP traps.
7. Click save.
Discover a Single Device
This features allows you to enter a single device for immediate entry into the discovery queue.
For example, if a new server has been added to your environment and you want to monitor it
immediately, it can be added here. The discovery process will then determine the characteristics
of this device and map it to an available license type: Infrastructure, Server, Workstation, or
Promoted Workstation. Depending on system load, a single device can usually be discovered
within at least five minutes.
Note: If a device is already discovered, adding the device again will not discover it twice. Only
newly discovered devices are added to the currently managed set of devices.
1. Click on the Admin tab in the top navigation bar.
2. Click Discover a Single Device under Tools.
Figure 33 Discover a Single Device
3. Enter either a NetBIOS name, a hostname, or an IP address.
4. Click discover.
Note: If two devices have the same NetBIOS name, only one will be discovered.