Raritan Computer COMMANDCENTER NOC - Manual (Page 93)

CHAPTER 6: CONFIGURING NOTIFICATIONS 81
Configure Notification Paths
In this section, you will create notification paths that defines the users or groups who will receive
notifications, how the notifications will be sent, for example, numeric or text pagers, email, and
who to notify if escalation is needed. Notification paths are selected when configuring an event
notification and should be created before configuring an event notification – please see section
Configure Event Notifications earlier in this chapter for additional information.
Note: Numeric and text pagers can be used to communicate with Telocator alphanumeric
protocol (TAP) paging providers. Please contact Raritan Technical Support for information
about how to configure the paging functions.
1. Click on the Admin tab in the top navigation bar.
2. Click Notification Configuration.
3. Click Configure Notification Paths.
Figure 100 Configuring a Notification Path
This page lists the default notification paths. Each path is listed and you may edit the definition of
the path by clicking edit or remove a path by clicking delete next to it. The next section explains
how to add a new notification path or edit one.
Add/Edit a Notification Path
To add a new notification path, click new path and you will be walked through the configuration
of a new notification path as described in the next few steps.
Clicking edit next to a notification path follows the same steps, allowing you to edit information
already defined for the path, but allows you to change the path name, path criteria, and escalation
criteria instead of entering new data.