Raritan Computer COMMANDCENTER NOC - Manual (Page 88)

76 COMMANDCENTER NOC ADMINISTRATOR GUIDE
6. Click one of the radio buttons:
• To NOT build a rule, click Do not constrain notice against interface or service.
• To build a rule, click Send notice only if it contains an interface that matches the
interface/service rule below.
7. If you selected to build a rule, specify TCP/IP address and service information that needs to
match the interface and service information contained in the event to send the notification.
Enter the following:
a) A TCP/IP address where filtering can occur within any of the four octets.
Functions/operators supported within an octet include:
• Address lists (space-delimited)
• Octet value ranges (the dash "-" operator)
• Octet value lists (the comma "," operator)
• Octet value wildcards (the asterisk "*" operator)
For example:
TCP/IP Address
Example Explanation
192.168.1.1
100.101.102.103 Matches two specific addresses.
192.168.0,1,2,5,21.1 Matches 192.168.0.1, 192.168.1.1, 192.168.2.1, etc.
192.168.1.* Matches any address with 192.168.1 in the first three
octets.
192.168.0.1-99 Matches 192.168.0.1, 192.168.0.2, 192.168.0.3, etc.
Another example: The following fields are all valid and would each create the same result set--all
TCP/IP addresses from 192.168.0.0 through 192.168.255.255:
192.168.*.*
192.168.0-255.0-255
192.168.0,1,2,3-255. *
b) Once you've created the TCP/IP address filter, you can select any service(s) you would
like to add as a filter constraint in conjunction with the TCP/IP address just specified. For
example, highlighting both HTTP and FTP will match TCP/IP addresses that support HTTP
OR FTP.
You can select multiple individual services by holding down the Ctrl key while clicking on
your selections. Additionally, you can select ranges of services by clicking on one end of the
range, holding down the Shift key, and clicking on the opposing end. This functionality is
supported by most browsers. If it does not work in your browser, please consult the
documentation provided by your browser vendor.
Note: Choosing no services will include all services in this filter. To reset any TCP/IP address or
services selected, click reset values.