Roland SC-88 Pro - Manual (Page 101)

■ Creating and saving an Insertion effect (User Effect)
Insertion effect parameter settings that you make can be saved in memory. An
Insertion effect that you save in this way is referred to as a User Effect. 64 User Effects
can be stored.
* For the function of each parameter, refer to the applicable page. (p.57)
● Saving a User Effect
1.
Set the Insertion effect parameters.
(“Insertion effect settings,” p.56)
2.
Press the [EFX] button to make the indicator light orange.
Caution is required at this point-- if you happen to change the effect type, all the effect
parameters will revert to their defaults.
3.
Simultaneously press [EFX] and [ON/OFF].
The display will ask “
Write U.EFX 01?
” Use INSTRUMENT [ l ][ r ] to select the
number (01 to 64) where you wish to store the data.
4.
To store the data, press [ALL].
To cancel without storing, press [MUTE].
5.
Press [EFX] to turn off the indicator and complete the procedure.
To load the User Effect that was stored, use the following procedure.
1. Press the [ALL] button to make the indicator light orange.
2. Press EFX TYPE [ r ] to display 64 PH/Auto Wah.
3. Then press EFX TYPE [ r ], and the User effect will be selected.
The “ X ” symbol of the effect number indicates that this is a User effect.
INSTRUMENT PART
LEVEL PAN
REVERB CHORUS
KEY SHIFT MIDI CH
SELECT
EFX ON/OFF
USER
INST
VIB RATE
ATTACK
VIB DEPTH
CUTOFF
DECAY
VIB DELAY
RESONANCE
RELEASE
DELAY
EFX VALUE EFX PARAM EFX TYPE
ALL
MUTE
SC-55
MAP
SC-88
MAP
2
3
4
5
3
PART INSTRUMENT
A01
100 0
LEVEL PAN
01 Stereo-EQ x
Chapter 5. Convenient functions 99