Regency E33-NG - Manual (Page 11)

11
E33 FPI Direct Vent Gas Insert
INSTALLATION
5) Re-install the grate (reverse step 3).
6) Line up the pin holes (located at the bottom
of log 03-23) to the pins of the rear log sup-
port and position them into place. (refer to
Diagram 3)
Diagram 3
03-23
Locating Pins
03-23
03-17
03-21
Diagram 5
7) Align the bottom grooves of log 03-21 onto
the right side of the grate and gently slide
the log back until it touches the locating tab
(refer to Diagram 4 & 5).
Diagram 4
Locating
Tab
03-21
12) Place log 03-19 over the left center of the
grate. Ensure the log set looks like Diagram
12.
11) Place log 03-24 over log 03-23 and log 03-21
ensuring the pin hole of log 03-24 lines up
with the right pin of log 03-23 and the right
pin of log 03-21 (refer to Diagram 11).
03-24
03-23
03-21
Locating
Pins
Diagram 11
Diagram 10
03-17 03-20
03-23
03-22
03-18
Tab
03-20
03-18
03-23
Locating
Pins
Diagram 9
10) Place log 03-18 over log 03-23 and log 03-20.
Ensure the pin hole of log 03-18 lines up with the
middle pin of log 03-23 and the right pin of log
03-20 (refer to Diagram 9 & 10).
Diagram 8
03-22
Locating
Pins
03-23
03-20
8) Align and position the pin hole of log 03-20
down into the left locating pin of log 03-21.
Slide into the groove and gently place into
position until it touches the locating tab.
(see Diagram 6 & 7)
Diagram 6
Locating
Tab
03-20
Locating
Pin
03-21
9) Place log 03-22 over log 03-23 and
log 03-20. Ensure the pin hole of log
03-22 lines up with the left pin of log
03-23 as well as the left pin of log
03-20 (refer to Diagram 8).
Diagram 7
03-21
03-17
03-23