Other printing problems, 4other printing problems – Ricoh AP505 User Manual
Page 53
Other Printing Problems
35
4
Other Printing Problems
Status
Possible Causes, Descriptions, and Solutions
Image is printed on the re-
verse side of the paper.
The paper in the paper tray is upside down.
• Standard Tray (Tray 1)
Load paper with the print side up.
• Bypass Tray
Load paper with the print side down.
• Optional Paper Feed Unit (Tray 2, Tray 3)
Load paper with the print side up.
Paper misfeeds occur fre-
quently.
Check the paper size settings. The size specified with
the paper size dial might be different from the actual
paper size. Make the correct dial setting.
Check if the paper tray is set correctly. If not, set it cor-
rectly.
P.25 “Loading Paper in the Paper Tray”
Paper is not loaded correctly in the paper tray. Remove
the paper from the tray and reload it correctly.
“Loading Paper in the Paper Tray”
Check the paper type settings. The type of paper set
with the printer driver might be different from the ac-
tual paper or media type. Make the correct paper or
media type setting.
You might use paper not supported by this printer. Use
the appropriate type of paper.
Multiple pages are fed
through the printer at once.
Clean the friction pad, if it is dirty.
Operation panel error mes-
sage stays on after removing
the misfed paper.
After removing misfed paper, open the front cover of
your printer and then close it.
It takes too much time to
print the first page.
The data is so large or complex that it takes time to pro-
cess it. If the Data In indicator is blinking, the data pro-
cessing is being done. Just wait until it resumes.
The Energy Save mode might be enabled. In the Ener-
gy Save mode, it takes time for the machine to warm
up.