Radio Shack 43-3857 - Manual (Page 18)

Memory Dial
ing
18
The screen appears with the memory location
number that you have selected in the display.
3. Press MEM or REMOTE/SELECT .
4. Press VOL or VOL to select Edit
MemoryXX . Then press MEM or REMOTE/
SELECT .
Store Name is displayed. The cursor flashes
indicating that the display is ready for the name
to be edited. When a name has not been
stored, the cursor appears at the beginning of
the second line.
5. Use the number keys, /TONE/< , #/ > , or CH/
DELETE to edit the name. (See “Storing Phone
Numbers and Names” on page 13.) To edit only
the phone number, skip this step.
6. Press MEM or REMOTE/SELECT .
The cursor flashes indicating that the display is
ready for the number to be edited.
7. Use the number keys, /TONE/< , #/ > , PAUSE/
REDIAL or CH/DELETE to edit the phone
number.
The phone number cannot exceed 20 digits.
If you don’t want to change the phone number,
skip this step.
8. Press MEM or REMOTE/SELECT . If you changed
either name or phone number, a confirmation
display shows up. If it is correct, press
VOL
to select Yes and press REMOTE/SELECT. You
hear a confirmation tone. The memory storage
is complete.
For example, if you store a name and number
into memory location number 01, the display
shows
Memory01 Stored . After about two
seconds, Select Memory screen is displayed.
9. Press END to return to standby mode.
43-3857.book Page 18 Wednesday, February 18, 2004 12:40 PM