Radio Shack 900MHz - Manual (Page 12)

12 Installation
To connect the phone to a single
one-line phone jack, plug one end of
the supplied long modular cord into
TEL LINE 1/2 or TEL LINE 2 .
Note: If you connect the phone to a
single one-line phone jack, avoid
pressing the unused line button or
you might hear feedback.
2. Plug the supplied AC adapter’s bar-
rel plug into DC IN 9V on the back of
the base.
3. Route the adapter’s cord through
the strain relief slot on the bottom of
the base.
4. Plug the adapter into a standard AC
outlet.
5. Connect the phone cord(s) to the
modular phone jack(s).
6. Raise the base’s antenna to a verti-
cal position.
On a Wall Plate or a Wall
Note: To mount the base directly on the
wall, you need two screws (not supplied)
with heads that fit into the keyhole slots
on the bottom of the bracket.
1. Drill two holes 3 15 /
16
inches apart.
Then thread a screw into each hole,
letting the heads extend about 5 /
16
inch from the wall.
2. Insert the two tabs at the top of the
wide end of the supplied bracket
into the base’s lower tab slots as
shown, then press down on the
bracket’s latches and insert them
into the clip slots.
3. Connect the phone line as
described in “On a Desk Top” on
Page 11.
4. Insert the supplied AC adapter’s
barrel plug into DC IN 9V on the back
of the base.
5. Route the adapter’s cord through
the narrow groove on the bracket. If
you are using two phone cords,
route the second cord through one
of the wide grooves on the bracket.
6. To mount the phone on a wall plate,
plug the other end of the short mod-
ular cord into the wall plate jack,
then align the bracket’s keyhole
slots with the wall plate studs and
slide the base downward to secure
it. If you are using two phone cords,
plug the second cord into the sec-
ond phone jack.
To mount the phone directly on a
wall, align the bracket’s keyhole
DC IN 9V