Remote operation, Using the toll-saver, Using remote commands – Radio Shack 900MHz User Manual

Page 26

Advertising
background image

26

Remote Operation

ˆ

Remote Operation

While you are away from your home or
office, you can use a touch-tone phone,
or a pulse (rotary) phone with a pocket
tone dialer (available through your local
RadioShack store) to enter your PIN and
do any of the following:

• set the phone to answer or not

answer calls

• listen to your messages

• record a new outgoing message

• erase messages

• monitor the room where the phone

is located

Notes:

• You cannot remotely operate the

phone using its handset or another
telephone on the same line as the
phone.

• You can also listen to the message

recorded on Line 2 by making a call
to Line 1’s number (or vice versa).

USING THE TOLL-SAVER

If

RING TIME

is set to

TS

(toll-saver),

(see “Setting the Number of Rings” on
Page 15), the phone answers after three
rings if you have new messages (ones
you have not listened to). If there are no
new messages, the phone answers after
five rings. This gives you time to hang
up before the phone answers so you
can avoid unnecessary long-distance
charges.

Note: Toll-saver works only on the line
you called. If Line 1 has no new mes-
sages, but Line 2 has one, the tele-
phone answers after five rings when you
call Line 1.

USING REMOTE
COMMANDS

Follow these steps to operate the phone
from a remote location.

Note: If you wait more than 15 seconds
between keypresses, the phone sounds
a long beep and hangs up.

1. Dial your phone number and wait for

the phone to answer.

2. If the phone is not set to answer

calls, it answers after about 10 rings
and sounds a series of beeps.

3. When the outgoing message begins

(or the phone sounds a series of
beeps), press

#

, then enter your PIN

within 2 seconds.

If the PIN is correct, the phone announc-
es the day and time, then it announces
the number of new and old messages.
The phone plays all new messages,
then beeps about every two seconds to
let you know it is ready to accept remote
commands.

Notes:

• If the phone does not respond, try

entering your PIN again. If you enter
an incorrect PIN three times, the
phone beeps and hangs up.

Advertising