RAD Data comm ASMI-450 - Manual (Page 67)

ASMi-450 Control from the Control Port
ASMi-450 Installation and Operation Manual 4-9
4.5 ASMi-450 Command Set Description
This section describes the ASMi-450 commands. The commands are listed in
alphabetical order. The description includes command format, use, and options.
The following notational conventions are used below:
[ ] square brackets indicate optional entry/parameter
' ' single quotes delimit user entry
<CR> indicates the pressing of the carriage return key
CLR ALM --------------------------------------------------------------------------------------
Purpose Clear the alarm buffer.
Format CLR ALM [/A]
Use 1. To clear only alarms of the ON type stored in the alarm buffer (see Table 5-1):
CLR ALM<CR>
2. To clear all the alarms stored in the alarm buffer (including ON/OFF alarms):
CLR ALM /A<CR>
3. You will see the time and date, followed by the ASMi-450 prompt.
CLR LOOP ------------------------------------------------------------------------------------
Purpose Deactivate the specified user-initiated loopback or test.
Format CLR LOOP [looptype] or CLR LP [looptype]
Use 1. To deactivate the local (L) loopback on the user's port of the local ASMi-450, type:
CLR LOOP L PORT<CR> or CLR LP L PORT<CR>
2. To deactivate the remote (R) loopback on the user's port of the remote ASMi-450,
type:
CLR LOOP R R PORT<CR> or CLR LP R R PORT<CR>
3. You will see the time and date, followed by the ASMi-450 prompt.
4. If no loopback of the specified type is now activated, you will receive ERROR 2.