Functions of performance parameters, Settings common to the entire performance (common) – Roland XP-30 User Manual
Page 83
83
Chapter 3. Creating Your Own Sounds
Chapter 3
Functions of Performance
Parameters
fig.3-11
■
Settings Common to the Entire
Performance (COMMON)
This display is used when setting parameters that are not part of
other groups. These include Performance Name and Key Mode.
PERFORM NAME (Performance Name)
You can assign a name to the Performance of up to 12 characters.
* For details on assigning names, refer to
PERFORM CLOCK
Some parameters allow you to set a time value in terms of a
note length which is determined by a specified tempo; Rate
parameters (PATCH/LFO/LFO1, 2), Time parameter
(PATCH/WAVE/TONE DELAY), and some Multi-Effects
parameters. The specified tempo used by these parameters
can be set for each Patch. However when a Patch is used in
Performance mode, the Patch settings will be ignored, and
the settings of this display will be used instead.
Source (Performance Clock Source)
Select the source of the Performance Clock.
PERFORM:
Synchronize to the Performance Tempo setting.
SYSTEM:
Synchronize to the tempo clock of the ststem.
* The Performance Clock does not transmit clock messages from
MIDI OUT connector.
Tempo (Performance Tempo)
Set the Performance Tempo setting.
* When Source (Performance Clock Source) is set to SYSTEM,
synchronization will be according to the tempo clock of the
system, so it will not be possible to set the tempo value. The
tempo of the system will be displayed in parentheses ( ).
PERFORM COMMON
Key Mode
This parameter determines how the sound source will be
played from the XP-30’s keyboard.
LAYER:
When you play the keyboard, all Parts whose Local
parameter (PERFORM/MIDI/MIDI) is turned on
will sound. Transmission of MIDI messages from
the controller section to external MIDI devices will
be determined by the Tx parameter setting
(PERFORM/MIDI/MIDI) of each Part.
SINGLE:
When you play the keyboard, only the specified
Part (the Part shown in the display) will sound.
MIDI messages will be transmitted from the
controller section to the external MIDI devices
even if the Local parameter and Tx parameter
settings for each Part (PERFORM/MIDI/MIDI)
are turned off.
* If you have selected a Layer-type Performance, the upper right of
the PERFORM PLAY display will indicate “