Roland XP-30 - Manual (Page 88)

88
Chapter 3. Creating Your Own Sounds
Functions of Rhythm Set
Parameters
fig.3-16
■ Naming a Rhythm Set
(COMMON)
RHYTHM NAME (Rhythm Set Name)
You can assign a name of up to 12 characters to a Rhythm
Set.
* For details on assigning names, refer to “Assigning a Name”
(p. 46).
■ Setting Effects for a Rhythm Tone
(EFFECTS)
* Rhythm Sets use the effect settings of the Performance currently
selected in Performance mode. You can modify the Performance
effect settings from inside Rhythm Set mode, but they are not
stored as Rhythm Set settings. If you wish to keep the effect
settings, you need to store them as Performance settings.
OUTPUT
Specify the output for each key.
Output Assign (Output Assign/Output Level)
For the output of each key, specify whether or not it will be
sent through Multi-Effects, and adjust the volume level.
MIX: output to the OUTPUT jack without passing through
Multi-Effects.
EFX: output to the OUTPUT jack after passing through
Multi-Effects.
Chorus (Chorus Send Level)
Adjust the amount of Chorus for each key.
Reverb (Reverb Send Level)
Adjust the amount of Reverb for each key.
PERFORM EFX TYPE
(Performance EFX Type)
* If EFX Source has been set to use the EFX parameter settings of
the Patch assigned to one of the Parts, the Part number will be
shown in the upper left of the display.
Type (EFX Type)
Select the type of EFX. For details refer to “Multi-Effects
Types (EFX Parameter)” (p. 93).
* If you have selected the EFX parameter settings of one of the
Patches assigned to a Part as the EFX Source, the EFX Type of
that Patch will be displayed.
Source (EFX Source)
Select the EFX parameter settings that will be used by the
Performance. If you wish to use the EFX parameter settings
of the Performance, select PERFORM. If you wish to use the
EFX parameter settings of the Patch assigned to one of the
Parts, select the Part number.
PERFORM EFX PRM
(Performance EFX Parameters)
The EFX parameters for the selected EFX Type will be
displayed. For details refer to
“Multi-Effects Types (EFX
Parameter)” (p. 93).
* If EFX Source has been set to use the EFX parameter settings of
the Patch assigned to one of the Parts, the Part number will be
shown in the upper left of the display.
PERFORM EFX OUT
(Performance EFX Output)
These parameters specify the output for the keys for which
EFX was selected in Output Assign.
* For keys which have an Output Assign setting of MIX, the
settings of this display will be ignored.
Mix Out (EFX Output Level)
Adjust the volume of the direct sound and Multi-Effects
sound.
Chorus (Chorus Send Level)
Adjust the amount of Chorus applied to the sound that
passes through Multi-Effects.
Reverb (Reverb Send Level)
Adjust the amount of Reverb applied to the sound that
passes through Multi-Effects.
When the EFX Parameter Settings of a
Patch Are Selected
When the EFX parameter settings of a Patch are
selected, those settings will be displayed in the EFX
parameter setting display of the Performance, and you
will be able to modify them. If you wish to keep the
Patch EFX parameter settings that you modify, rewrite
the Patch settings. The modified Patch EFX parameter
settings will be lost if you select a different Patch.