Ricoh CL3000DN - Manual (Page 58)

Troubleshooting
54
5
Call Service: EC
Power Off On A communication error sent
from the engine to the control-
ler. Turn the power switch off and
on. If the message appears
again, contact your sales or
service representative.
Cannot check
Signal in Ad hoc The signal strength for the
wireless LAN cannot be
checked because "Ad hoc" is
selected in "Comm. Mode" for
"IEEE 802.11b" in the Host In-
terface menu. Change the transmission
mode to [Infrastructure] in the
Host Interface menu.
Change Setting
Tray #
/Paper Size:
Paper Type:
The paper size or paper type
set in the indicated tray differs
from the setting made.
#: tray number
Load paper of the selected size
and type in the tray, and then
change the paper setting with
the control panel.
Or press the {{{{Form Feed}}}} key
several times until the tray
with the desired paper type
and paper size appears on the
panel display.
Or press the {{{{Job Reset}}}} key to
cancel the print job.
Close Front and/
or Right Cover
The front or right cover of the
printer is open. Close the front or right cover
of the printer.
Close Upper Left
Cover
The upper left cover of the
printer is open. Close the upper left cover of
the printer.
Color Regist
Error
Color registration has failed. Turn the power switch off and
on. If the message appears
again, contact your sales or
service representative.
Error: Tray #
Form Feed
/Reset The Job
Then Power OffOn
There is a problem with the in-
dicated tray.
#: tray number or Bypass Tray
Press the {{{{Form Feed}}}} key to
select another tray and make a
print, or turn the power
switch off and on. If the mes-
sage appears again, contact
your sales or service repre-
sentative.
Hardware Problem
Black PCU
An error has occurred in the
black PCU (Photo Conductor
Unit). Turn the power switch off and
on. If the message appears
again, contact your sales or
service representative.
Messages/Second messages Description Solution
AresPGBMaintGuide-F_FM.book Page 54 Friday, July 26, 2002 5:17 PM