RCA TruFlat T20TF668 - Manual (Page 12)

10 Chapter 1
Connections & Setup
Connection: TV/VCR + Satellite Receiver
1. Connect the satellite receiver to the TV/VCR
A. Connect one end of an RF coaxial cable (not included) to the TV/VCR’s
ANT/CABLE jack. Connect the other end to the satellite receiver’s antenna output
jack (sometimes labeled OUT TO TV).
B. Connect the A/V cables. Connect audio cables to the TV/VCR’s LINE IN/IN 1
AUDIO (L and R) jacks and the other ends to the satellite receiver’s corresponding
audio output jacks. Connect one end of the video cable to the TV/VCR’s LINE IN/
IN 1 VIDEO jack, and the other end to the satellite receiver/cable box’s video
output jack.
2. Connect antenna or cable to your satellite receiver
Connect the coaxial cable from your antenna, cable feed, or cable box to the Antenna
Input jack on the satellite receiver (sometimes labeled IN FROM ANT).
3. If necessary, connect the satellite’s antenna cable to the satellite receiver
If the coaxial cable from the satellite dish antenna isn’t already connected to the
satellite receiver’s input jack (sometimes labeled SATELLITE IN), connect it now.
Go To Page 11
Note: The back of
your satellite receiver
might not look
exactly like the one
shown here.
CH3
CH4
S-VIDEO
L R VIDEO
OUT
IN FROM ANT
OUT TO TV SATELLITE
IN
From
Satellite
Satellite receiver
back panel
VIDEO
LINE IN ANT/CABLE
75
LINE COMPONENT-IN
IN 1
L
R
L
R
P R
(C R )
P B
(C B )
OUT
AUDIO
AUDIO VIDEO
TV/VCR back panel
From Antenna/Cable Feed
Y
3
1A
1B
TV/VCR
2
Note: If you have model
T27TF668, the placement
of the jacks is different
from the TV/VCR back
panel illustrated here.