RCA TruFlat T20TF668 - Manual (Page 21)

Chapter 2 19
The Remote Control
Using Direct Entry
1. Turn on the component you want the remote to operate.
2. Look up the brand and code number(s) for the component on the code list on page 20.
3. Press and hold component button that corresponds to the component you want the remote
to operate (VCR2, DVD, etc.)
4. Enter the code from the code list on page 20.
5. Release the component button.
6. Press ON•OFF to see if the component responds to the remote commands. If it doesn’t, try
pressing the component button and then ON•OFF again.
7. If you get no response, repeat these steps using the next code listed for your brand, until
the component responds to the remote commands.
How to Use the Remote After You’ve
Programmed It
Once the remote has been programmed successfully, you are ready to use it to control your
components. To operate the component:
1. Press the component button (VCR2, DVD, AUX, or SAT•CABLE) to set the remote to control
the component.
2. Press ON•OFF to turn the component ON or OFF.
3. Use the remote buttons that apply to that component.
Notes:
• If you keep pressing buttons and nothing happens, the remote is probably in the
wrong mode. You must press the component button that matches the component you
want to operate (i.e., if you want to operate the DVD player, press DVD on the remote
control to put the remote in DVD mode.)
• The buttons might operate differently for other components, especially when you’re
using another component’s menu system.
How to Order A New Remote Control
To order a new remote control or other accessories to use with your TV/VCR, go to Accessory
information in Chapter 5.