Radio Shack Camcorder Model 130 Moviecorder - Manual (Page 30)

30
2. Set AV OUT/IN inside the AUDIO/VIDEO
OUT/IN jack compartment for the audio
source you chose:
• If you are using the built-in microphone,
set AV OUT/IN to OUT .
• If you are using an audio source con-
nected to the camcorder’s AUDIO jack,
set AV OUT/IN to IN .
3. Slide POWER to VCR .
4. Insert a cassette into the camcorder.
5. Press PLAY on the camcorder to find the
portion of the tape where you want to start
audio dubbing. Then press
REC/PAUSE to
pause it.
6. Press PLAY and DUBBING AUDIO/VIDEO
together once. appears in the
viewfinder.
Note: If does not appear in the
viewfinder, press STOP/EJECT , then press
PLAY and DUBBING AUDIO/VIDEO together
once to continue.
7. If you are not using the camcorder’s built-in
microphone as an audio source, start the
audio source.
8. To start audio dubbing, press REC/PAUSE
on the camcorder.
9. Press STOP/EJECT on the camcorder to
stop dubbing.
Notes:
• To set the position where you want to end
audio dubbing, start playback of the tape,
press
DISPLAY on the camcorder at the
point where you want to end audio, then
start the dubbing process.
• To prevent feedback squeals, turn down the
volume control on any TV or TV/monitor
connected to the camcorder.
AUDIO/VIDEO EDITING
When you use audio/video editing, you can re-
place the audio and video on a tape with new
sound and pictures.
You can use sounds picked up by the camcord-
er’s built-in microphone or signals from an audio
source connected to the camcorder’s
AUDIO
jack. You can use pictures taken by the camera
or signals from a video source connected to the
camcorder’s
VIDEO jack.
Notes:
• If you connect an audio/video source,
always use video quality shielded cables
with phono-type connectors (such as Cat.
No. 15-1540, not supplied) to connect the
camcorder’s
AUDIO and VIDEO jacks to the
source’s AUDIO OUT and VIDEO OUT
jacks.
• Do not use standard audio cables for this
connection.
1. If you are not using the camcorder’s built-in
microphone as an audio source, connect
the audio source’s AUDIO jack to the cam-
corder’s
AUDIO jack.
2. Set AV OUT/IN inside the AUDIO/VIDEO
OUT/IN jack compartment for the video
source you chose.
• If you are using the camcorder’s lens, set
AV OUT/IN to OUT .
• If you are using a video source con-
nected to the camcorder’s VIDEO jack,
set AV OUT/IN to IN .
3. Slide POWER to VCR .
IN OUT
16-830.fm Page 30 Wednesday, July 21, 1999 9:32 AM