Radio Shack Camcorder Model 130 Moviecorder - Manual (Page 31)

31
4. Insert a cassette into the camcorder.
5. Press PLAY on the camcorder to play the
tape to the point where you want audio/
video dubbing to end. Then press
REC/
PAUSE to pause it.
6. Press DISPLAY . M appears in the view-
finder next to the tape counter. Then press
RESET to reset the tape counter to 0000 .
7. Press REWIND to rewind the tape past the
point where you want to start audio/video
dubbing, then press
PLAY . When you see
the point of the tape where you want to
start audio/video dubbing, press
REC/
PAUSE .
8. Press PLAY and DUBBING AUDIO/VIDEO
together twice. and the picture you
are dubbing appear in the viewfinder.
Note: If you accidentally press PLAY and
DUBBING AUDIO/VIDEO together only
once, appears in the viewfinder
instead. If this happens, simply press PLAY
and DUBBING AUDIO/VIDEO together again.
9. Press REC/PAUSE on the camcorder.
Audio/video dubbing begins.
When the tape counter shows 0000 , the
camcorder automatically stops the tape,
and video and audio dubbing stop.
Notes:
• To protect the tape and conserve battery
power, the camcorder automatically
stops and turns itself off if left in the
record/pause mode for more than 5 min-
utes.
• To prevent feedback squeals, turn down
the volume control on any TV or TV/
monitor connected to the camcorder.
10. Press STOP/EJECT on the camcorder to
stop audio/video dubbing at any time.
16-830.fm Page 31 Wednesday, July 21, 1999 9:32 AM