Radio Shack Camcorder Model 130 Moviecorder - Manual (Page 34)

34
5. Using the supplied 75-ohm antenna cable,
connect the RF converter’s OUT TO TV jack
to the TV’s VHF antenna terminal.
• If the TV’s VHF antenna terminal is the
round, 75-ohm type, connect the cable
directly to the terminal.
• If the TV’s VHF antenna terminal is the
flat, 300-ohm type, use another matching
transformer (such as Cat. No. 15-1253,
not supplied) to connect the cable to the
terminal.
6. Set CHANNEL on the RF converter to 3 or 4 .
PLAYBACK
After you connect the camcorder to your TV, fol-
low these steps to play a tape.
1. Turn on the TV, then:
• If you are using a TV with audio/video
(A/V) jacks, set it to the video mode.
• If you are using a standard TV, set the
TV’s tuner to the same channel where
you set
CHANNEL on the RF converter ( 3
or 4 ).
2. Slide POWER on the camcorder to VCR .
3. Insert a cassette into the camcorder.
4. Press PLAY on the camcorder. The tape
plays on your TV.
5. Press STOP/EJECT to stop playback. Press
STOP/EJECT again to remove the cassette.
CHANNEL
16-830.fm Page 34 Wednesday, July 21, 1999 9:32 AM