RCA HD65W40 - Manual (Page 20)

Connections & Setup
18 Chapter 1
Why You Should Connect the G-LINK™ Cable
The G-LINK cable enables the GUIDE Plus+ system (the on-screen interactive program guide) to
work with your VCR and/or cable box.
Cable Box – If your TV is connected to a cable box, you must connect the G-LINK cable to receive
TV program listings for your area and to tune directly to a channel when the program guide is on
your TV screen.
VCR – If your TV is connected to a VCR and you don’t connect the G-LINK cable, one-touch VCR
recording and timed recordings won’t work. The other features of the guide will work properly.
Tips
If you have both a VCR
and a cable box, it
doesn’t matter which
wand is connected to
which box.
If you don’t have both a
cable box and a VCR
connected to your TV,
just coil the cable of the
extra G-LINK wand with a
twist tie and leave it
behind the TV.
VIDEO INPUT 1
AUDIO INPUT 1
L/MONO
R
VIDEO INPUT 2
AUDIO INPUT 2
S-VIDEO S-VIDEO
VIDEO INPUT 3
AUDIO INPUT 3
V
L/MONO
R
V
L/MONO
R
V
PB
Y
PR
L/MONO
R
VIDEO INPUT 4
AUDIO INPUT 4 AUDIO INPUT 5
L/MONO
R
V
PB
Y
PR VIDEO INPUT 5
R
L
LEFT
EXT
SPEAKER SELECT INTERNAL
SPEAKER SOURCE
EXTERNAL AMPLIFIER MAXIMUM POWER RATING! (60 WATTS into 8 OHMS)
CENTER CHANNEL INPUT
RIGHT FIXED/VARIABLE AUDIO OUTPUT
EXTERNAL SPEAKERS
TV EXT AMP INT W/ EXT SURR
ANTENNA A INPUT ANTENNA B INPUT
ETHERNET
G-LINK
VIDEO
RECORD
OUTPUT
AUDIO
R
L
DIGITAL AUDIO OUTPUT
TV
VCR
03
CHANNEL SENSOR SENSOR
Connect to G-LINK jack
on the back of the TV
.
TV (back panel)
DVI-HDTV
G-LINK wands
G-LINK cable
4. When the component turns on, you’ve located the VCR’s or cable box’s remote sensor.
Placing the G-LINK Wands
Place the G-LINK wands in front of the remote sensor on your VCR and/or cable box
approximately one inch away from the remote sensor (see below).
VCR
03
CHANNEL
CABLE BOX
How to Find the Remote Sensor
You have to place the G-LINK wands in front of the remote sensor on the VCR and/or cable box.
Some cable boxes and VCRs have the remote sensor labeled on the unit. If the remote sensor isn’t
labeled on your VCR and/or cable box, you need to use the remote control that came with the
VCR and/or cable box to locate the sensor.
1. Turn off the VCR and/or cable box.
2. Hold the remote control (not the one that came with your TV, but the one that came with the
cable box and/or VCR to which you’re attaching the G-LINK cable) so that it is touching the
front of the component.
3. Slowly move the remote control across the front of the component (VCR or cable box) while
you press the power button on and off. You must press and release the power button each
time you move the remote (holding down the button won’t work).