Connections & setup, Things to consider before you connect, Protect against power surges – RCA HD65W40 User Manual
Page 8: Protect components from overheating, Use indirect light, Using a stand, Connection illustrations
Connections & Setup
6
Chapter 1
Things to Consider Before You Connect
Protect Against Power Surges
•
Connect all components before you plug any of their power cords into the wall outlet or
power strip. NEVER plug your TV into an outlet that is controlled by a wall switch.
•
Turn off the TV and/or component(s) before you connect or disconnect any cables.
•
Make sure all antennas and cables are properly grounded. Refer to the Important Safeguards
sheet packed with your TV.
Protect Components from Overheating
•
Don’t block ventilation holes on any of the components. Arrange the components so that air
can circulate freely.
•
Don’t stack components.
•
When you place components in a stand, make sure you allow adequate ventilation.
•
If you connect an audio receiver or amplifier, place it on the top shelf so the heated air from it
won’t flow around other components.
Position Cables Properly to Avoid Audio Interference
•
Insert each cable firmly into the designated jack.
Use Indirect Light
Don’t place the TV where sunlight or room lighting will be directed toward the screen. Use soft or
indirect lighting.
Using a Stand
If a stand or base is used, ensure that it is of adequate size and strength to prevent the TV from
being accidentally tipped over, pushed off, or pulled off. This could cause personal injury and/or
damage the TV. Refer to the Important Safety Instructions packed separately.
Connection Illustrations
The components used in the connection illustrations are for representation only. The input jacks
and the output jacks on the back of your components (VCR, DVD player, etc.,) might look different
than those illustrated.