RCA CC9360 - Manual (Page 17)

Connections & Setup
Chapter 1 15
Turn off the camcorder
1. Set the Power switch to OFF.
2. Close the LCD monitor.
Powering the Camcorder
You can power your camcorder with a battery or AC
power.
Charging the Battery
1. Set the Power switch to OFF.
2. Raise the viewfinder.
3. Slide the battery into the back of the camcorder.
Make sure the arrow diagram on the battery
points down so that the contacts on the battery
and camcorder match.
Important: If the battery pack is attached in
the wrong position, a malfunction may occur.
4. Plug the small end of the power supply into the
DC IN jack on the camcorder and the other end
into an AC outlet. (The CHARGE indicator
blinks.)
5. When the CHARGE indicator stops blinking but
stays on, charging is finished. Make sure the
Power switch is set to OFF, then unplug the
power supply from the AC outlet and from the
camcorder.
Important: Before detaching the power
source, make sure the camcorder’s power is
turned off. Failure to do so can result in a
camcorder malfunction.
BLAN K SEA RCH
FOCUS +
+
BAT. RELEASE
P LA
Y
O
FF
Power switch
BLANK SEAR
CH
FOCUS +
+
BAT. RELEA SE
EXPOSURE BACK LIGHT
NIGHT ALIVE P .AE MENU/ BRIGHT SNAP SHOT VOL. CHAR GE