RCA CC9360 - Manual (Page 45)

Recording
Chapter 3 43
Blank Search
Helps you find where you start recording in the
middle of a tape to avoid time code interruption.
1. Press in the Lock button while setting the Power
switch to
(playback mode). (The POWER
indicator comes on.)
2. Press BLANK SEARCH. (BLANK SEARCH appears
and blinks, and the camcorder starts to search.
The tape stops a few seconds before the next
blank spot.
• To cancel Blank Search, press .
Notes:
• If the current position is at a blank spot,
the camcorder searches in the reverse
direction. If the current position is at a
recorded spot, the camcorder searches in
the forward direction.
• If the beginning or end of the tape is
reached during Blank Search, the
camcorder stops automatically.
• A blank spot shorter than 5 seconds may
not be detected.
• The detected blank spot may be located
between recorded scenes. Before
recording, double check that there is no
recorded scene after the blank spot to
avoid recording over it.
• Blank Search doesn’t work if HEAD
CLEANING REQUIRED. USE CLEANING
CASSETTE appears when a tape is loaded.
BLAN K SEA RCH
FOCUS +
+
BAT. RELEASE
P LA
Y
O
FF
Power switch
Lock
button
BLANK SEARCH button