Raritan Computer II - Manual (Page 80)

70 P ARAGON II U SER M ANUAL
Rear Mount
1. Secure the cable-support bar to the front end of the side brackets, near the side brackets’ “ears,” using
two of the included screws.
2. Slide the User Station or Base Unit between the side brackets, with its rear panel facing the cable-
support bar, until its front panel is flush with the back edges of the side brackets.
3. Secure the User Station or Base Unit to the side brackets using the remaining included screws (three on
each side).
4. Mount the entire assembly in your rack and secure the side brackets’ ears to the rack’s front rails with
your own screws, bolts, cage nuts, etc.
5. When you attach cables to the connectors on the rear panel of the User Station or Base Unit, drape
them over the cable-support bar.
Figure 62 Rear rackmount of a P2 Base Unit
Figure 63 Rear rackmount of a P2 User Station
1.
1.
2.
3.
3.
4.
4.
5.
P2-UMT328
1.
1.
2. 3.
3.
4.
4.
5.
P2-UST