Ryobi RY30130 - Manual (Page 11)

11
OPERATION
STARTING AND STOPPING
See Figures 5 - 7.
TO START A COLD ENGINE:
DO NOT squeeze the throttle trigger until the engine starts
and runs.

Lay the trimmer on a flat, bare surface.
 PRIME - Press the primer bulb 7 times.
 SET the start lever to the START position.
 PULL the rope until the engine starts.
 Wait 6-10 seconds, then squeeze the trigger to run.
NOTE: Squeezing the throttle trigger releases the start lever
to the
RUN position.
TO START A WARM ENGINE:
PULL the rope until the engine starts.
TO STOP THE ENGINE:
Press and hold the switch in the stop “ ” position until
the engine stops.
Fig. 5
THROTTLE
TRIGGER
IGNITION
SWITCH
TRIGGER
LOCK
Fig. 6
THROTTLE TRIGGER
IGNITION
SWITCH
Fig. 7
PRIMER BULB
START POSITION
RUN POSITION
START LEVER
START LEVER
TRIGGER LOCK