Ryobi RY30130 - Manual (Page 4)

4
SPECIFIC SAFETY RULES
SPECIFIC SAFETY RULES FOR TRIMMER
USE
 Replace string head if cracked, chipped, or damaged
in any way. Be sure the string head is properly installed
and securely fastened. Failure to do so can cause serious
injury.
 Make sure all guards, straps, deflectors, and handles are
properly and securely attached.
 Use only the manufacturer’s replacement string in the
cutting head. Do not use any other cutting attachment.
To install any other brand of cutting head to this string
trimmer can result in serious personal injury.
 Never operate unit without the grass deflector in place
and in good condition.
 Maintain a firm grip on both handles while trimming.
Keep string head below waist level. Never cut with the
string head located over 76 cm (30 in.) or more above the
ground.
SPECIFIC SAFETY RULES FOR EDGER USE
 Clear the work area before each use. Remove all objects
such as rocks, broken glass, nails, wire, or string which can
be thrown or become entangled in the edger blade.
� Be sure all guards are properly and securely attached.
� Replace dull or worn blade; do not attempt to sharpen.
� Use this edger for edging along sidewalks, driveways,
flower beds, and similar areas. Do not use for any other
purpose.
� Be thoroughly familiar with the controls. Know how to
stop the unit and disengage the controls quickly.
� Do not use edger in rain or wet locations.
 Do not use the edger on or near graveled surfaces.
 If the edger strikes any type of foreign object:
a) Stop the edger and remove the spark plug wire or
disconnect from the power supply.
b) Inspect for damage to the edger attachment .
c) Correct damage before using the edger attachment.
Failure to do so can cause serious injury.
 Make yourself familiar with the area you are edging. Be
aware of uneven sidewalks and holes in the terrain as well
as other similar hazardous conditions
(example: wire or
wire rope which can break off and become a dangerous
projectile). Always push the edger attachment slowly over
rough ground.
 Always stop the engine and remove the spark plug wire
before attempting to remove any obstruction caught or
jammed in the blade, installing attachment, or making
any adjustments.
� Do not attempt to remove cut material nor hold material
to be cut when the engine is running or when the cutting
blade is moving.
� Keep hands and feet away from the cutting area.
� Always keep your right hand on the rear handle and your
left hand on the front handle when the blade is rotating.
WARNING:
A coasting blade can cause injury while it continues
to spin after the engine is stopped or throttle trigger
released. Maintain proper control until the blade has
completely stopped rotating.