Roland HPi-6s - Manual (Page 16)

16
Before You Begin Playing
■ Attaching the Music Rest
The music rest of the HPi-6S contains a liquid crystal display screen.
Use the following procedure, and handle the music rest with care.
1. Secure the music rest in place by turning the included
screws (at two points).
When attaching the music rest, support it firmly with one hand to
make sure that you don’t drop it. Be careful, so you don’t get
your fingers pinched.
fig.MusicRest
2. Connect the LCD cord of the music rest to the LCD Out
connector on the rear panel of the HPi-6S.
The power must be off when connecting the cable of the
music rest.
fig.LCDCord-e
Do not apply excessive force to the installed music rest.
Be sure to use the supplied screws for attaching the music
rest.
Before moving the piano, be sure to remove the music rest to
prevent accidents.
Be careful not to lose the screws used to fasten the music
rest, or allow small children to accidentally swallow them.
■ Using the Music Holders
You can use the holders to hold pages in place.
When not using the holders, leave them folded down.
fig.MusicHolders
■ Connecting the Pedal Cord
1. Insert the end of the pedal cord extending from the piano
stand to the Pedal connector located at the lower part of
the HPi-6S’s rear panel.
fig.PedalCord
■ Connecting the Power Cord
1. Make sure that the [Power] switch located at the left side
of the front panel is off (in the upward position).
2. Turn the [Volume] knob all the way toward the left to
minimize the volume.
3. Connect the included power cord to the AC inlet located at
the rear of the bottom panel.
Setting Up for Performing
View from Rear
Screw Screw
NOTE
LCD Cord
NOTE
NOTE
NOTE
NOTE
Pedal Cord
OFF
Upward
position
On
Lower
position
HPi-6S-e.book 16 ページ ２００７年１１月１９日 月曜日 午前１０時３６分