Ricoh Aficio MP 2500 - Manual (Page 45)

Turning Off the Main Power / In the Event of Power Failure
37
3
Turning Off the Main Power / In the Event of
Power Failure
This section describes the machine status when the power is turned off or if the
power fails.
R CAUTION:
Important
❒ Do not turn off the main power switch while the operation switch indicator is
lit or blinking. If you do, the memory may be damaged and failure could result.
❒ Turn off the main power switch before pulling out the plug. If you pull out
the plug with the switch on, the memory may be damaged and failure could
result.
❒ Make sure that 100% is shown on the display before you unplug the machine.
If a lower value is shown, some data is currently present in memory.
❒ Right after a power failure, the internal battery needs to be sufficiently re-
charged to guard against future data loss. Keep the machine plugged in and
the main power switch on for about 5 days after the power loss.
Even if the main power switch is turned off, the contents of the machine memory
(for example, programmed numbers) will not be lost. However, if power is lost
for about twelve hours because the main power switch is turned off, there is a
power cut, or the power cord is removed, contents of the Fax memory are lost.
Lost items will include any fax documents stored in memory using Memory
Transmission/Reception, Memory Lock, or Substitute Reception.
If a file was deleted from memory, a Power Failure Report is automatically print-
ed as soon as the power is restored.
This report can be used to identify lost files. If a document stored for Memory
Transmission was lost, resend it. If a document received by Memory Reception
or Substitute Reception was lost, ask the sender to resend it.
❖ RDS (Remote Diagnostic System)
If the machine has a problem, a service representative can perform various
settings over the telephone line from the service station. If you want to use
this function, change the User Parameter. See “Parameter Setting”, General
Settings Guide.
• When you disconnect the power plug from the wall outlet, always pull the
plug (not the cable).