Ricoh IS 2245 - Manual (Page 187)

Copy Paper
175
9
*3 Select [OHP Sheet] or [Thick Paper] in the display panel. See “Copying from the Bypass
Tray”, Copy Reference.
*4 Placing one sheet at a time is recommended. See “Copying from the Bypass Tray”,
Copy Reference.
*5 When loading paper, make sure the top of the stack is not higher than the limit mark
of the paper tray.
*6 The paper guide is immovable. If you want to change the size of paper placed in this
tray, contact your service representative.
*7 If you want to use thick (128–163 g/m 2 , 34 lb.–43.5 lb.) paper, select [Thick Paper] on
the display panel. See “Copying from the Bypass Tray”, Copy Reference.
*8 With paper longer than 433 mm, misfeeds, jams and creasing may occur. Make sure
that paper is placed correctly so that it feeds in straight.
*9 The horizontal size is 148–432 mm (5.8"–17") when the booklet finisher is installed.
*10 It is recommended to place one sheet at a time.
Important
❒ If you use damp or curled paper, a misfeed may occur.
Note
❒ Load paper into the Tray 1-4 with the print side up.
❒ Place paper in the LCT and bypass tray with the print side down.
❒ When using the bypass tray, it is recommended to set the paper orientation to
L.
❒ When loading OHP transparencies, check the front and back of the sheets,
and place them correctly, or a misfeed might occur. Set the paper orientation
to L and select A4L, 8
1 /
2
"×11"K as paper size.
❒ When using OHP transparencies, fan them for each use. If you store the sheets
in the tray, they may adhere and may cause feeding problems.
❒ When copying onto OHP transparencies, remove copied sheets one by one.
❒ If multiple-sheet jams occur, load the paper sheet by sheet.
❒ Postcards should be fed using the bypass tray. Select [Thick Paper] on the dis-
play panel. See “Copying from the Bypass Tray”, Copy Reference.
❒ When copying onto letterhead paper, the paper placing orientation is differ-
ent depends on which function you are using. See p.121 “Orientation-Fixed
Paper or Two-Sided Paper”.
❒ If you load paper of the same size in the same orientation in two or more
trays, the machine automatically shifts to the other tray when the first tray in
use runs out of paper. This function is called “Auto Tray Switching”. (How-
ever, if one tray has recycled or special paper, the settings of the other trays
must be the same for Auto Tray Switching to work.) This saves interrupting
a copy run to replenish paper when making a large number of copies. See
“General Features 1/4 Auto Tray Switching”, Copy Reference and p.55 “Tray
Paper Size: Tray 1–4”.
❒ The paper types you can select in System Settings are only general classifica-
tions. Copy quality for every kind of paper in a classification is not guaran-
teed. See p.176 “Unusable Paper” for details.
AdonisC4-AE_zen_F_FM_forPaper.book Page 175 Thursday, May 12, 2005 3:32 PM