Regency NATURAL GAS U32-NG4 - Manual (Page 10)

10 U32-4 FPI Direct Vent Gas Insert
6) Place the Left Top Log D)02-46 on the pin
on Log C)02-56 and on top of the cutout
on Log A)02-43.
7) Place the notch in Center Log E)02-47 over
Log B)02-45 and across the cutout on Log
A)02-43.
8) Position notch in Front Right Log F)02-48
on Log E)02-47 and push the bottom right
edge against the bracket on the burner tray
and the front edge of the rear burner.
Logs D)02-46 and E)02-47 in position.
Notch
Bracket
Cutout Pin
D)02-46
C)02-56
A)02-43
Cutout Notch
E)02-47
B)02-45
A)02-43
Logs A)02-43, C)02-56,
and B)02-45 in position
Pins on Rear Log Support
A)02-43
B)02-45
C)02-56
3) Place Rear Log A)02-43 on the two pins on
the rear log support.
4) Place Front Right Log B)02-45 on the two
pins as shown.
5) Place the Middle Left Log C)02-56 on the
two pins as shown.
F)02-48
B)02-45
E)02-47
INSTALLATION
LOG SET
INSTALLATION
Read the instructions below carefully and
refer to the diagrams. If logs are broken
do not use the unit until they are replaced.
Broken logs can interfere with the pilot
operation.
The gas log kit contains the following:
a) 02-43 Rear Log
b) 02-45 Front Right Log
c) 02-56 Middle Left Log
d) 02-46 Left
Top Log
e) 02-47 Center Log
f) 02-48 Middle Right Log
g) 02-44 Front Left Log
h) Embers
i) Rockwool
j) Vermiculite
Note: Install Optional Brick Panels prior to
installing logs.
The "02" refer numbers (i.e. 02-43) are
molded into the rear of each log.
1) Carefully remove the logs from the box and
unwrap them. The logs are fragile, handle
with care - do not force into position.
2) Sprinkle the vermiculite around the fi rebox
base. Take some of the embers (approx.
1/3 of the bag) and sprinkle over the
vermiculite.
Vermiculite
and embers.
Vermiculite
and embers.
Vermiculite
and embers.