Roland PCR-80 - Manual (Page 130)

130
Edit mode (EDIT)
Advanced mode 1–3
Advanced mode 1 of AFTERTOUCH ASSIGN lets you specify the upper and lower limits of the
aftertouch value in addition to the items of Basic mode. Advanced modes 2 and 3 let you specify an
aftertouch message for an individual note (Polyphonic Key Pressure) instead of specifying the channel.
1. Press the [EDIT] button.
2. Slightly move the controller to which you want to assign an Aftertouch message. In the
case of a button, press that button.
The display will indicate the number of the selected controller.
3. Verify that the display indicates the correct controller, and press the [ENTER] button.
4. Press the [AFTERTOUCH] key and then press a key [1] – [3] .
The display will indicate the selected mode.
fig.at1
5. Press the [ENTER] button.
6. Input the channel.
7. Press the [ENTER] button.
8. If you are using Advanced modes 2 or 3 , input the note number.
9. If you are using Advanced modes 2 or 3 , Press the [ENTER] button.
10. If you are using Advanced modes 1 or 3 , specify the upper limit and lower limit of
the value as described in “Aftertouch Assign upper/lower limit and port settings”
(p. 131), and specify the output port.
11. If you are making an assignment for a button, specify the button mode.
(➔ “Specifying the button mode” (p. 158))