Roland PCR-80 - Manual (Page 145)

145
Edit mode (EDIT)
13. To specify “2” for the upper bits, press the [2] key.
The display will indicate “2BL”.
14. Confirm what’s indicated and press [ENTER] .
15. In the same way, enter bytes 8.
16. Since the ninth byte is the data area, press the [DATA] key.
The display will indicate “DT0.”
17. Confirm what’s indicated and press [ENTER] .
18. Since the ten byte will contain the checksum, press the [CHECKSUM] key to specify the location at which the
checksum will be input.
The display will blink “CS1” (Checksum Type 1).
19. Confirm what’s indicated and press [ENTER] .
20. Press the [F] and then [7] keys to input the ending status “F7.”
21. Confirm what’s indicated and press [ENTER] .
22. Next, specify an upper limit value of “58” for the data area.
23. Press [ENTER] .
24. Specify a lower limit value of “40” for the data area.
25. Press [ENTER] .
26. Specify the output port.
(➔ “Specifying the port” (p. 159))
27. If you are making an assignment for a button, specify the button mode. (➔ “Specifying the button mode”
(p. 158))
The GS Bend Pitch Control message has been assigned.