Vitek VT-1662 - Manual (Page 7)

7
ENGLISH
• Leave at least 7-8 cm of space behind
and on the sides of the oven and 30 cm
of space above the oven.
• Do not remove the supporting legs
from the bottom of the microwave
oven.
• Do not block the ventilation openings on
the body of the microwave oven.
• Place the unit away from the television
and radio receivers to avoid interferences
while receipt of tele – and radio signals.
NOTE: Never place the microwave oven
on the surface with heating (stove) and
other heated sources.
If the microwave oven is broken due to the
fault of the owner, it loses the right for free
warranty service and repair.
During the operation the surface of the
microwave oven can heat up strongly,
avoid contact with heated surface of
the oven, in order to avoid getting of
burns.
OPERATION
Sound signal
Pressing buttons on the control panel you
will hear sound signals.
Setting current time
For example you need to set the current
time “6:00” (АМ or РМ):
1. Insert the plug into the socket.
2. Press the “clock” button.
3. Press the “stop” button.
4. Press the “1 minutes” button to set
hours six times.
5. Press the “clock” button to confirm the
preset time, the dots (33) will be flashing
on the display.
Note: In this model a 12-hour time mode
is used. To display the current time during
the operation of the unit, press the “clock”
button.
Setting cooking time and power level
For example you need to set the cooking
time of 5 minutes at 60% power level:
1. Press the “microwaves” button, the in-
dication (25) will light up.
2. Set the operating time by pressing the
“1 minutes” button five times.
3. Set the required power, by pressing the
“power” button three times.
4. Press the “start” button, the indication
(35) will light up.
Note: while setting 100% power level the
third step is not necessary.
During cooking the indication (35) will light
up on the display and countdown of the
remaining cooking time starts. After the
cooking time is over, the unit will switch off
– three sound signals will be heard. If you
have forgot to take the products out of the
unit, then in two minutes the repeated three
sound signals will remind you about it.
Start cooking time setting
You want to start cooking at 2:00 o’clock
(АМ orРМ):
1. Press the “preset” button, the indica-
tion (28) will light up.
2. Set the time to start cooking, by press-
ing the “1 minutes” button twice.
3. Set the required cooking mode.
4. Press the “start” button, the indication
(28) will be flashing.
Note: make sure that the current time is
set properly.
When the preset time 2:00 is reached
cooking process will start. During cooking
the remaining cooking time and the cor-
responding operating mode indication are
displayed. After the cooking time is over,
the unit will switch off – three sound signals
will be heard. If you have forgot to take the
products out of the unit, then in two min-
utes the repeated three sound signals will
remind you about it.
1662.indd 7 1662.indd 7 24.06.2008 12:47:46 24.06.2008 12:47:46