Omega Vehicle Security freedom OM-550 - Manual (Page 28)

OM-550 u 23 u
4.1 PROGRAMMING KEYS
Pressing the PROG key activates the Program mode. The unit immediately prints the
current programming information and prompts the user to select a channel to
reprogram:
Figure 4-1
Channels may be defined as Voltage, Temperature (T/C) or Skipped. To save paper
and speed programming, the definitions for Skipped channels are not printed in the
above listing.
The EXIT key may be pressed at any time to leave the Program mode. All completed
programming will be retained but partial entries will be ignored.
The OK key is used only during programming. It lets the user accept the current setting
and advance to the next item to be programmed. This is helpful if only one or two
features need to be changed and they are in the middle of the programming menu.
For example, if the channel information is correctly programmed, but you wish to
change the Log Interval, use the OK key to break out of the channel-programming loop
and reset the Log Interval. The following example shows how to set the Log Interval to
1 minute, then exit the Program mode:
Figure 4-2
PRESS OK
THE SELECTION IS ECHOED
PRESS 000100 EXIT
PROGRAMMING COMPLETED
CURRENT TIME AND DATE
LOG INTERVAL AND REJECTION FREQUENCY
ONLY TWO CHANNELS ARE ACTIVE
A #KEY, OK, OR EXIT MUST BE PRESSED.
DATA CACHE INFORMATION
THE PROGRAM COMMAND