Oricom 8000 - Manual (Page 25)

24 CLOCK & ALARM
Clock & Alarm
If you subscribe to your network’s Caller ID service, the time on
the unit may be set automatically each time you receive a call,
depending on your network provider.
You can also set or adjust the time manually using the Clock &
Alarm menu.
To set date and time
1. Press [ ] and scroll [ ] or [ ] to CLOCK/ALARM. Press
[ ]. Display shows DATE & TIME, then press [ ].
2. Enter the date using the format DD/MM e.g. 04/ 08 for 4th
August.
3. Press [ ] and enter the time using the 24 hour format
HH:MM, e.g. 14:45 for 2.45pm.
4. Press [ ] to confi rm.
5. Press [ ] to return to standby.
NOTE
The date and time is retained during a power failure or when the batteries are
discharged.
To set alarm
1. Press [ ], scroll [ ] or [ ] to CLOCK/ALARM and press
[ ].
2. Scroll [ ] or [ ] to SET ALARM and press [ ].
3. Scroll [ ] or [ ] to OFF, ON ONCE or ON DAILY and press
[ ].
4. If you select ON ONCE or ON DAILY, enter the time using the
24 hour format HH - MM e.g 14:45 for 2:45pm and press
[ ].
5. Press [ ] to return to standby. When the alarm goes off, press
any key to stop the ring.
NOTE
Once the alarm is set to on, the icon is displayed. The alarm will ring at the
medium level. ALARM ON and the will fl ash on the display.
To set alarm melody
There are three alarm ringtones.
1. Press [ ] and scroll [ ] to CLOCK/ALARM. Press [ ].
2. Scroll [ ] to ALARM TONE and press [ ]. Melodies are
played.
3. Scroll [ ] or [ ] and press [ ].