Oricom 8000 - Manual (Page 9)

8 GETTING STARTED
Wall mounting
IMPORTANT
Before you wall-mount your Slim, check that you are not drilling into any
hidden wiring. Before you drill, make sure the power and telephone line cables
will reach the sockets.
Method A. To fi t the wall bracket (supplied) to an
existing telephone wall plate with modular connector
simply;
1. Remove the base stand from the slim base unit if it was fi tted.
2. Fit the wall bracket (supplied) over the existing wall plate, slide
down until it locks in place.
3. Plug the AC adaptor cord into the base unit.
4. Plug the short telephone line cord (supplied) into the base unit
and plug the other end into the telephone wall plate socket.
5. Tuck the small line cord in the space provided, then position
the mounting holes on the base unit over the two protruding
plastic lugs on the wall bracket.
6. Gently push the base unit against the wall bracket then slide
the base downwards locking it into place.
7. Plug the AC adaptor into a power point.
holes
lugs
wall bracket (supplied)
Method B. Attach the Wall bracket (supplied) directly to a wall
1. Choose a suitable position to wall mount the base ensuring the
telephone line cord and the AC adaptor will reach the phone
socket and power point.
2. Mark out and drill two holes vertically, one above the other 100mm
apart (use the wall bracket as the template). Fix 2 screws (supplied)
leave the screw heads protruding from the wall by 5mm.
3. Plug the telephone line cord (supplied) into the base unit and
plug the other end into the telephone wall plate socket.
4. Plug the AC adaptor cord into the base unit.
5. Feed the line cord and the AC adaptor cable through the gap between
the base unit and the wall bracket, then position the mounting holes on
the base unit over the two protruding plastic lugs on the wall bracket.
6. Gently push the base unit against the wall bracket then slide
the base downwards locking it into place.
7. Plug the AC adaptor into a power point and connect the line
cord to the phone socket.
8 Place the handset in the base unit to charge.