Oregon Scientific BAR888RA - Manual (Page 8)

8
EN
STRONG SIGNAL WEAK SIGNAL NO SIGNAL
To force a manual search for Atomic Clock signals,
press and hold for 2 seconds. If no signal is found,
check the batteries.
NOTE If the Atomic Clock signal is received and the
hour is incorrect, use the “timezone offset” feature to
adjust it to the appropriate timezone. Please see “Set
Clock” section for instructions.
TURN ATOMIC CLOCK ON / OFF
Perform this step if you cannot receive Atomic Clock
signals. Press and hold for 2 seconds. Then, manually
set the clock following the “Set Clock” instructions.
The signal icon indicates that the Atomic Clock
feature is
ON. No icon means that it is OFF.
SET CLOCK
You only need to do this if you have disabled the Atomic
Clock feature (for example, if you are too far from or
cannot receive a signal).
1. Press and hold MODE for 2 seconds. The Clock
Area will blink.
SET ALARM
1. Press ((•)) to switch to alarm display.
2. Press and hold ((•)) again for 2 seconds. The alarm
settings will blink.
3. Select the hour and minute. Press or to
change settings. Press ((•)) to confirm.
2. Select the time zone, hour, minute, year, month, day,
and language. Press or to change the setting.
Press MODE to confirm.
NOTE The language options are (E) English, (F)
French, (D) German, (I) Italian, and (S) Spanish.
NOTE The time zone options are (PA) Pacific, (CE)
Central, (MO) Mountain, and (EA) Eastern.
SWITCH CLOCK DISPLAY
Press MODE to toggle between Clock with Seconds
and Clock with Weekday display.
ALARM
This product is equipped with a 2-minute crescendo
alarm.
VIEW ALARM SETTINGS
Press ((•)). The alarm time status will show in the Clock
Area.
BAR888RA_EN_R15 4/12/05, 9:43 AM 8