Oneida Air Systems 10 HP - Manual (Page 10)

VI. General Assembly Instructions
9
O.A.S. 2007 c 10 HP Pulley Drive Owner’s Manual
1. Determine mounting height for the cyclone.
- Height depends on size of Dust Bin and length
of Flex Hose to Dust Bin connection.
2. Mount Angle Iron Brackets to wall using included
hardware.
3. Mount Cyclone Barrel to Wall Brackets.
- Determine inlet orientation. Fasten Cyclone to
Brackets with one bolt on each side. Drill new
hole in ring if needed for your orientation.
6. Connect Cyclone Cone to Barrel using included
Clamp Ring.
- Seal around Clamp Ring with silicone.
7. Connect 14 to 10 Reducer to bottom of Cone.
8. Connect Sleeve Kit to Cyclone Cone and Dust Barrel
using included Band Clamps.
For cyclonic preseparation there must be an air
tight seal between cyclone and dust container.
Dust bin must be located vertically under cyclone.
Material drops down by gravity.
Inlet
Cyclone
Barrel
Angle Iron
Wall Brackets
Clamp
Ring
Cyclone
Cone
14 to 10
Reducer
Sleeve
Kit
55 Gal.
Steel
Drum
- Seal around Reducer with silicone.
Ideas for make your own Dust Bins:
- 55 gal. drum, metal or rigid plastic garbage can,
air-tight plywood box.
Note: You can make a lid using plywood lined with some
type of gasket material (Carpet Foam).
(Continued on next page.)
4. Lower V - Tube into Cyclone Barrel
5. Connect Outlet Cyclone Barrel to Inlet Cyclone
Barrel using included Clamp Ring.
V - Tube
Outlet
Cyclone
Barrel
Clamp
Ring