17 cordless handset operation, Registration – Oricom ECO70 User Manual

Page 19

Advertising
background image

17

CORDLESS hANDSET OpERATION

Note:
When the keypad is locked, [

] key and [ INT ] key can

be used to answer an external or intercom call.

Registration

Register new handsets on the eco70/700 base

The handsets which come in the same pack are already

registered to the base. If you buy new handsets. You need

to register them before use.
1. Charge the batteries (for 14 hours).
2. Register the handset (to the base unit).
the operation is different in eco70 and eco700.
In eco70, we need to set the base unit in registration mode

by resetting the base power.
In eco700, we can set the base in registration mode by

pressing and holding the base [ ] for 10s
Each base can register up to 5 handsets.
During standby mode,
1. Press and hold the [

] key for 3 seconds until both

the [ ] and [

] icons flash, then press and hold the

[

] key for 3 seconds. The following will appear on

the display.

2. Press 1 and the handset begins to search for the base.
3. Enter the base pin code (0000). If the pin is wrong, the

handset will restart searching for the base.

4. When the handset is registered, it will show “

HS”followed

by the handset number.

Note:
If the base is full and cannot add any more handsets, you
will hear a tone. See the next section to remove a handset.

Remove handsets

During standby mode,
1. Press and hold the [

] key for 3 seconds, then press

and hold the [ ] key for 3 seconds.

2. Enter the default value 0000. If the pin is wrong, the

handset will go back to standby.

3. Press the numeric keys (1-5) to enter the handset number

you want to remove.

4. The unit will go back to standby if the removal is

successful.

Note:
You can only remove other handsets in your system but
you are not able to remove the handset you are using.

Advertising
This manual is related to the following products: