Oricom ECO70 - Manual (Page 21)

19 ANSWERING MAChINE OpERATION (ECO700 ONLY)
Erasing the Outgoing Message
Erase the outgoing message as follows:
• Select the desired outgoing message by pressing and
hold the [ ] key.
• Press the [ ] key to play the outgoing message.
• Keep pressing the [ ] key when the OGM is played
back.
Turning Answering Machine On/Off
If the answering machine is on, the 2x7 segment LED
display will light up and the machine will automatically pick
up the line after a number of rings (see “Setting number of
Rings” ).
• Press the [
] key to switch on the answering
machine. The 2x7 segment LED will be turned on.
• Press the [ ] key again to switch off the answering
machine. The 2x7 segment LED will be turned off.
Note:
• Even if the answering machine is off, the machine will
automatically pick up after 16 rings in order to enable
remote activation (see “Remote Operation” ).
Setting number of Rings
The number of rings after which the answering machine
will answer calls can be set from 2 – 9 and TS (Toll saver).
The standard setting is 3 rings. In Toll saver mode, the
machine will answer after 5 rings if there are no new
messages, and after 2 rings if there are new messages. If
there are no new messages and you call your machine to
check your messages remotely (See “Remote Operation”),
you can hang up after the 2nd ring. You do not need to pay
connection fees and you know that you do not have any
new messages.
• Briefly press the [
] key. The display will show the
current numbers of rings.
• Press the [ ] key for 2 secs to set the number of
ringing tones.
• Press the [ ] or [ ] key to change the
current number of rings.
• Confirm the setting by pressing the [ ] key.
• If you do not press any keys for 3 seconds, the machine
will revert back to the answering machine menu, without
changing the settings.
• If there is a loss of power in the base, the number of
rings will revert to 5.