SUUNTO Stinger - Manual (Page 68)

66
You are able to preset alarms before the actual dive. The user programmable alarms
can be set for maximum depth, dive time and daily time. The alarms activate when:
• The preset maximum depth is reached
- continuous beep series for 24 seconds or until any button is pressed.
- the maximum depth blinks as long as the present depth value exceeds the
adjusted value.
• The preset dive time is reached
- continuous beep series for 24 seconds or until any button is pressed.
- the dive time blinks for one minute, if no button is pressed.
• The preset alarm time is reached
- the current time is shown.
- continuous beep series for 24 seconds or until any button is pressed.
- the current time blinks for one minute, if no button is pressed.
OXYGEN ALARMS IN EAN MODE
Three double beeps and the backlight activated for 5 seconds occur when:
• the OLF bar graph reaches 80%. The segments exceeding the 80% limit
start to blink (Fig. 3.23.)
• the OLF bar graph reaches 100%. All the OLF bar graph segments start to
blink.
The blinking of the segments will stop when the OLF is not loading anymore. At
that point the PO
2
is less than 0.5 bar.